Please register to gain full access of the forum.
When you register please use your given name.handles and fake names will be deleted. if you are deleted you can re-register with your real name.
Hello All,
I'm looking for the steel side mount for the Unimount that fits a McCulloch engine. Based on my set up the aluminum side mounts will not work. Any help would be greatly appreciated.
Thanks
Chris
Hey Dan, for the note.
The issue with the GEM mounts is the thickness not the height. I'm running an inboard clutch and the original steel side mount was thinner than the GEM mounts by roughly 1/4 inch.
Hey Dan, Thanks for the pictures and information. I'm going to mock up a mount using something 3/8 thick and see if I have clearance. I've been told anything over 1/4 will cause problems. Do the mounts pictured have the McCulloch bolt pattern?
Thanks
Chris
Hey Bob,
That looks like the part I need. How thick is it? I'm assuming that is a McCulloch bolt pattern. If your willing to sell it, I'm at 708-267-9706.
Thanks