 |
| |
| Please register to gain full access of the forum. When you register please use your given name.handles and fake names will be deleted. if you are deleted you can re-register with your real name. |
| Moderated by: Kevin Gagne | ||
| Author | Post | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
Jeffrey Sligh
|
Got two HL184C Tillys on the Mac motor, they have the double pumper on them and a 1" bore, but I am trying to find out for sure if these are the right carbs to be running alky with. Also, anyone know where to get parts for these little jokers? I tried the Tillotson website, but they don't even list HL184C on the site. Need the gaskets of course, and I figure that any of the HL series gasket kits will work, but I am also needing the tops for them.Anyone know of a place to get the parts and if these are the right carbs? |
|||||||||||
Paul Booth
|
Hi Jeff, The HL 185C carb was made for the Solo Chainsaw Company in Germany, I will look tomorrow at my shop to see if I have a parts breakdown for it. go fast and have fun, Paul |
|||||||||||
Paul Booth
|
Hi Jeff, Disregard my above post as I looked at the wrong carb. The 184A was made for Polaris but I do not have a !84C listed. Go fast and have fun, Paul |
|||||||||||
Terry Sullivan
|
Jeff, Give these guys a call. I'm sure they would rather sell you new carbs, but they have a lot of Tilly knowledge. https://www.eccarburetors.com/ terry |
|||||||||||
Jeffrey Sligh
|
Ok, thanks to really old parts and small stamped letters, I found out that these are actually HL194C carbs... Sorry about the confusion. Guess I might need to get me a set of readers. LOL! |
|||||||||||
