View single post by Mike Berg | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Wed Sep 23rd, 2020 03:30 pm |
|
||||||||||||
Mike Berg
|
Just a suggestion. My experience with ethanol gas in 2 strokes is not good, the ethanol will swell the inlet needle or seat depending on which type you have, this lowers the fulcrum arm severly limiting the amount of fuel your carb can pass. reset the top of your fulcrum so it is just the thickness of the fulcrum above the floor of the casting. Do not use ethanol fuel. Good Luck.
|
||||||||||||
|