Please register to gain full access of the forum.
When you register please use your given name.handles and fake names will be deleted. if you are deleted you can re-register with your real name.
Hi everyone
Great to see the forum back on line.
I have a Yamaha KT135 rotary engine & I am informed that the conrods are fragile.
My engine runs fine but I want to replace the rod before I run it to much.
Any info or parts would be appreciated.
Thanks
Bob
Hi Jerry
It is a KT135cc rotary & it would be strange if a 100cc KT100AX rotary rod fitted.
Do you know for sure that a KT100AX rod will fit?
I have talked about my motor before on this forum & the reaction was they did not know a Yamaha 135cc rotary existed.
i have a kt100 with a 57.0 bore. still uses stock rod. didn't come from the factory that way. check with lynn haddock. he would know if one was ever made.
Last edited on Wed Apr 5th, 2017 11:13 am by Chuck Giacobbe
Hi Chuck
Rest assured this is a Yamaha 135cc they ran them over here in Australia & I know a couple of other guys that have them.
I tried to upload some pics but they were too big, send me your email address & I will send you some pics.
They are nothing like a KT100.
bob, i'm not saying i doubt you. i'm just saying lynn would have a lot of information about it. if anybody would know he would. he sells on ebay under the name choo---choo (that's 3 dashes inbetween). ask him a question thru one of his listings. ask him if he uses the same rod.