 | PM |  | | Quote | | | Reply | | | Full Topic | |
| Joined: | Tue Jul 6th, 2021 |
| Location: | Washington USA |
| Posts: | 4 |
| Status: |
Offline
|
| Mana: |  |
Thanks Pat
Attachment: IMG_2181.JPG (Downloaded 46 times)
| Close Window | |
| View single post by Tigershark | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Posted: Sat Jul 31st, 2021 11:35 pm |
|
||||||||||||
Tigershark
|
I purchased a engine Powwr Bee 820 on E-Bay that had all the bolts loctited in except the manifolds/stuffer . The crank had plates welded on the counter weights. There we a through the rod journal. (See attached picture). The bearings were staked in. My question was this 820 used as a hot saw or what. It had no ordinary mount and the bolts were loctited. Had a devil of time getting them out. Attached is a pictures of the welded crank with a hole through the rod journal. Any answers would be appreciated. Thanks Pat Attachment: IMG_2181.JPG (Downloaded 46 times)
|
||||||||||||
| |||||||||||||