 | PM |  | | Quote | | | Reply | | | Full Topic | |
| Joined: | Tue Dec 21st, 2010 |
| Location: | Fostoria, Ohio, USA |
| Posts: | 64 |
| Status: |
Offline
|
| Mana: |  |
In the 90's it was common for 3rd bearing supports to be drilled for both the Parilla and Yamaha on the base plate. I usually cnc my own with a specific hole pattern for the engine I plan to use it on, but I have a few of the dual bolt pattern mounts in use on some of my karts that I bought. Odenthal and others sold them that way.
Hello Michael,
Your right, some plates came pre-drilled for the Parilla and Yam. I've given probably 3 of them away over the years. Now I need one, go figure.
The plate I have now, was drilled after. Holes are oversize, not de-burred, etc. BUT... It will work. I laid it out last night, the pattern is straight in relation to the upright mount.
I talked to the folks at Odenthal, very nice folks and very helpful. They don't have anything in stock, but would make me one if needed.
I worked on the program last night to CNC an upright. Just figured if someone had a complete unit I could have cleaned it up to look pretty and move on.
Frankie
| Close Window | |