 | PM |  | | Quote | | | Reply | | | Full Topic | |
| Joined: | Tue Dec 21st, 2010 |
| Location: | Fostoria, Ohio, USA |
| Posts: | 64 |
| Status: |
Offline
|
| Mana: |  |
My base plate is blue, so I assume it was out Mark's shop (Hi-Rev). I've called without sucess. Plus this looks to have been originaly made for a yam, as the TT-25 pattern has been added.
Where the upright mounts is three holes on 1" C/L's.
The C/L of the engine bolt pattern sits back from the Center upright mounting hole aox 14 MM's.
From the base of the engine to the C/L of the crank is 61 MM.
I have an old Burris upright along with an unknown, the three mount holes spacing is different. Plus they are set up with the old big bearing that was used with the DXL's with the extended hub. I'll be using a L&T.
Thank you Terry for taking the time to look.
| Close Window | |